Lunatic Pack - State Protection (YEP) - Revision history

Yanfly at 10:43, 13 June 2020

2020-06-13T10:43:10Z

Yanfly at 18:34, 30 October 2019

2019-10-30T18:34:56Z

Yanfly at 18:08, 26 June 2019

2019-06-26T18:08:04Z

Yanfly at 00:47, 22 June 2019

2019-06-22T00:47:26Z

Yanfly: Created page with "{{MvPlugin |preview=https://www.youtube.com/watch?v=wW_FzGu5SqU |link1= 2019-06-20T17:49:21Z Created page with "{{MvPlugin |preview=<youtube>https://www.youtube.com/watch?v=wW_FzGu5SqU</youtube> |link1=<html><iframe src="https://itch.io/embed/398306" height="167" width="552" frameborder..." New page<div>{{MvPlugin |preview=<youtube>https://www.youtube.com/watch?v=wW_FzGu5SqU</youtube> |link1=<html><iframe src="https://itch.io/embed/398306" height="167" width="552" frameborder="0"></iframe></html> |link2=[http://yanfly.moe/plugins/en/YEP_Z_StateProtection.js Mirror] }} [[Category:RPG Maker MV Battle Plugins]] {{RequiredPluginsMV}} * [[Buffs & States Core (YEP)|Buffs & States Core]] {{Yanfly Engine Plugins}} == Help File == <nowiki> ============================================================================ Introduction ============================================================================ This plugin requires the following plugins: - Battle Engine Core - Buffs & States Core Place this plugin beneath the above listed plugins in the plugin manager. This plugin allows you to add a variety of protection effects to your states to allow them to reduce HP or MP damage in more unique ways, from cutting off a percentage of the original damage, blocking off damage entirely once certain break points are met, capping damage in certain ways, and surviving fatal damage. And should any of those effects trigger, you can set the state to perform special effects, too! NOTE: This plugin is best used with RPG Maker MV version 1.5.0+. You can still use this plugin with a lower version number, but you will have a much harder time altering the plugin parameters without it. ============================================================================ Notetags ============================================================================ Insert the following notetags into a skill or item's notebox to give it one of these effects: --- State Notetags: <Protection Animation: x> - If a protection effect goes off, it will display animation x on the protected unit. This animation will be played in place of the default animation to indicate the effect has taken place. <type Protection: effect> - Most of this plugin's notetags will follow the above format. 'type' will be replaced with either 'HP', 'MP', or 'Both' to indicate which damage types will be protected against. Replace 'effect' with one of the effects found below. Insert multiple entries of this notetag to give it multiple effects. The order of effects will be played by the order they're inserted into the notebox. =-=-=-= Protection EFFECTS =-=-=-= --- Damage Reduction --- <type Protection: Damage Cut x%> - Replace 'x' with a number. Will reduce damage by x% of the original damage value and not the current value. SUGGESTED BY: Yanfly <type Protection: Damage Block -x> <type Protection: Damage Block +x> - Replace 'x' with a flat value you wish to block (or increase) damage by. This is a flat change to the damage final value. SUGGESTED BY: Yanfly --- Damage Nullifiers --- <type Protection: Damage Null x%> - Replace 'x' with the percentage value of the target's MaxHP/MaxMP you wish to set as the break point. If the damage value is less than or equal to the break point, damage will be nullified and set to zero. SUGGESTED BY: Yanfly <type Protection: Damage Barrier x%> - Replace 'x' with the percentage value of the target's MaxHP/MaxMP you wish to set as the break point. If the damage value is less than or equal to the break point, damage will be nullified and set to zero. SUGGESTED BY: Yanfly --- Damage Cappers --- <type Protection: Damage Ceiling x%> - Replace 'x' with the percentage value of the target's MaxHP/MaxMP you wish to set as the break point. If the current damage value is above the break point, the damage value will become the break point. SUGGESTED BY: Yanfly <type Protection: Damage Floor x%> - Replace 'x' with the percentage value of the target's MaxHP/MaxMP you wish to set as the break point. If the current damage value is below the break point, the damage value will become the break point. SUGGESTED BY: Yanfly --- Death Cheaters --- <HP Protection: Guts x%> - Works only with HP type. Replace 'x' with the success rate percentage you wish to give this effect. If the affected target were to receive fatal damage as a result of this attack, there would be a x% chance the target would be able to survive with 1 HP left. This will not trigger if the target has exactly 1 HP left. SUGGESTED BY: Yanfly <HP Protection: True Guts x%> - Works only with HP type. Replace 'x' with the success rate percentage you wish to give this effect. If the affected target were to receive fatal damage as a result of this attack, there would be a x% chance the target would be able to survive with 1 HP left. Unlike the regular guts, this remain in effect even if the user is at exactly 1 HP left. SUGGESTED BY: Joshua Pactor <HP Protection: Fatal Damage Absorbx %> - Works only with HP type. Replace 'x' with the success rate percentage you wish to give this effect. If the affected target were to receive fatal damage as a result of this attack, the target would receive the damage as recovered health instead. SUGGESTED BY: Shaun Pattenden --- Triggers --- <type Protection: Trigger Removal x%> - If any of this state's protection effects have been triggered/activated, then remove this state as a result of the effect happening. Replace 'x' with the success rate you wish for this effect to occur. SUGGESTED BY: Yanfly <type Protection: Trigger Add x Buff> <type Protection: Trigger Add x Buff, y Turns> <type Protection: Trigger Add x Debuff> <type Protection: Trigger Add x Debuff, y Turns> - If any of this state's protection effects have been triggered/activated, then add a buff/debuff for parameter 'x'. Replace 'x' with 'MaxHP', 'MaxMP', 'ATK', 'DEF', 'MAT', 'MDF', 'AGI', or 'LUK'. You can replace 'y' with the number of turns the buff/debuff will last. If you do not use the notetag variant with the turn count, then it will default to 5 turns. SUGGESTED BY: Yanfly <type Protection: Trigger Remove x Buff> <type Protection: Trigger Remove x Debuff> - If any of this state's protection effects have been triggered/activated, then remove a buff/debuff for parameter 'x'. Replace 'x' with 'MaxHP', 'MaxMP', 'ATK', 'DEF', 'MAT', 'MDF', 'AGI', or 'LUK'. SUGGESTED BY: Yanfly <type Protection: Trigger Add State x> - If any of this state's protection effects have been triggered/activated, then add state 'x' onto the target. Replace 'x' with the state ID you wish to apply to the target. SUGGESTED BY: Yanfly <type Protection: Trigger Remove State x> - If any of this state's protection effects have been triggered/activated, then remove state 'x' onto the target. Replace 'x' with the state ID you wish to remove from the target. SUGGESTED BY: Yanfly =-=-=-= Examples =-=-=-= <HP Protection: Damage Cut 70%> - This will reduce incoming HP damage for the affected unit by 70% meaning only 30% of the damage will go through. <HP Protection: Damage Block -500> <HP Protection: Damage Null 20%> - This will reduce incoming HP damage for the affected unit by a flat 500 first. If the damage is less than 20% of the unit's MaxHP, then it will be nullified completely. <MP Protection: Damage Barrier 20%> - If the affected unit receives MP damage and the MP damage is more than 20% of the unit's MaxMP, nullify that damage completely. <HP Protection: Damage Ceiling 30%> - If the affected unit receives HP damage and the HP damage is more than 30% of the unit's MaxHP, then the damage will be reduced to equal 30% of the unit's MaxHP. <HP Protection: Guts 100%> <HP Protection: Trigger Removal 100%> - If the affected unit receives HP damage that would be fatal, the damage is reduced until the unit would be left with 1 HP left. At that point, the state that gives the Guts effect will be removed. ============================================================================ Lunatic Mode - Effect Code ============================================================================ For experienced users that know JavaScript and have RPG Maker MV 1.5.0+, you can add new notetag effects that can be used by the plugin or alter the effects of currently existing notetag effects from the plugin parameters entry: Effect Code. It should look something like this: --- // ---------------- // Damage Reduction // ---------------- if (data.match(/DAMAGE CUT[ ](\d+)([%％])/i)) { rate = parseFloat(RegExp.$1) * 0.01; blocked = originalValue * rate; value -= blocked; value = Math.max(value, 0); } else if (data.match(/DAMAGE BLOCK[ ]([\+\-]\d+)/i)) { blocked = parseInt(RegExp.$1); value -= blocked; value = Math.max(value, 0); ... // ------------------------------- // Add new effects above this line // ------------------------------- } else { skip = true; } --- Here's what each of the variables used in this code bit refer to: -------------------- --------------------------------------------------- Variable: Refers to: -------------------- --------------------------------------------------- state The state this effect belongs to stateId The state ID this effect belongs to value The HP/MP damage being affected by this effect. Any changes made to this value will be permanent unless the effect is skipped. originalValue The original HP/MP damage before any of the protect state effects have been applied. item The item being used by this action skill The skill being used by this action isItem Returns true if action is an item isSkill Returns true if action is a skill a Returns the action user user Returns the action user subject Returns the action user b Returns the action's current target target Returns the action's current target s[x] Return switch x (true/false) v[x] Return variable x's current value user._result The current results for the user target._result The current results for the target userPreviousResult The results for the user before any changes targetPreviousResult The results for the target before any changes animation The animation to be played. triggered Returns if any of this state's protection effects have been triggered (true) or not (false) skip Default: false. If true, skips popups & animations --- If you need to revert the Effect Code back to its original state, delete the plugin from your plugin manager list and then add it again. The code will be back to default. ============================================================================ Changelog ============================================================================ Version 1.01: - Bypass the isDevToolsOpen() error when bad code is inserted into a script call or custom Lunatic Mode code segment due to updating to MV 1.6.1. Version 1.00: - Finished Plugin! ============================================================================ End of Helpfile ============================================================================ </nowiki></div> </article> </main></body></html>

@@ Line 1: / Line 1: @@
 {{MvPlugin
 |preview = <youtube>https://www.youtube.com/watch?v=wW_FzGu5SqU</youtube>
 |link2 = <html><iframe src="https://itch.io/embed/508138" height="167" width="552" frameborder="0"></iframe></html>
 |link3 = <html><iframe src="https://itch.io/embed/398158" height="167" width="552" frameborder="0"></iframe></html>

@@ Line 2: / Line 2: @@
 |preview = <youtube>https://www.youtube.com/watch?v=wW_FzGu5SqU</youtube>
 |link1 = <html><iframe src="https://itch.io/embed/398306" height="167" width="552" frameborder="0"></iframe></html>
-|link2 = [http://yanfly.moe/plugins/en/YEP_Z_StateProtection.js Mirror]
+|link2 = <html><iframe src="https://itch.io/embed/508138" height="167" width="552" frameborder="0"></iframe></html>
 }}

@@ Line 33: / Line 33: @@
 </nowiki>
-== Notetags ==
+{{Notetags MV}}
   <nowiki>
@@ Line 190: / Line 190: @@
 </nowiki>
-== Lunatic Mode - Effect Code ==
+{{Lunatic Mode MV}}
   <nowiki>
@@ Line 286: / Line 286: @@
 </nowiki>

@@ Line 1: / Line 1: @@
 {{MvPlugin
-|preview=<youtube>https://www.youtube.com/watch?v=wW_FzGu5SqU</youtube>
+|preview = <youtube>https://www.youtube.com/watch?v=wW_FzGu5SqU</youtube>
-|link1=<html><iframe src="https://itch.io/embed/398306" height="167" width="552" frameborder="0"></iframe></html>
+|link1 = <html><iframe src="https://itch.io/embed/398306" height="167" width="552" frameborder="0"></iframe></html>
-|link2=[http://yanfly.moe/plugins/en/YEP_Z_StateProtection.js Mirror]
+|link2 = [http://yanfly.moe/plugins/en/YEP_Z_StateProtection.js Mirror]
 }}
@@ Line 12: / Line 12: @@
 {{Yanfly Engine Plugins}}
-== Help File ==
+== Introduction ==
   <nowiki>
 This plugin requires the following plugins:
 - Battle Engine Core
@@ Line 35: / Line 31: @@
 still use this plugin with a lower version number, but you will have a much
 harder time altering the plugin parameters without it.
-============================================================================
+== Notetags ==
 Insert the following notetags into a skill or item's notebox to give it one
 of these effects:
@@ Line 192: / Line 188: @@
    is reduced until the unit would be left with 1 HP left. At that point, the
    state that gives the Guts effect will be removed.
-============================================================================
+== Lunatic Mode - Effect Code ==
 For experienced users that know JavaScript and have RPG Maker MV 1.5.0+, you
 can add new notetag effects that can be used by the plugin or alter the
@@ Line 277: / Line 273: @@
 plugin from your plugin manager list and then add it again. The code will be
 back to default.
-============================================================================
+== Changelog ==
 Version 1.01:
 - Bypass the isDevToolsOpen() error when bad code is inserted into a script
@@ Line 289: / Line 285: @@
 - Finished Plugin!
 </nowiki>